Sharkbite insertion depth

It is not required for Copper or CPVC, however, it is not necessary to remove the tube liner from the fitting. Mark the pipe to the correct insertion depth. Refer to insertion depth chart above.

PUSH: Push pipe and fitting together up to the depth mark. Nominal Size of Tubing Tubing . For Copper tube mark the pipe using. SharkBite F7Gauge with the proper insertion depth.

The gauge is also used to mark the depth to. Using the appropriate depth marker, or ruler, mark the insertion depth on both . Pull the tube to ensure that the joint is secure. Sharkbites over priced depth gauge tool . Fully insert pipe into the fitting and check the insertion depth.

On the side of the fitting marked “SLIP EN” slide the PVC pipe into the fitting until it reaches the tube stop. I double checked the insertion depth but Bang, it happened again. Once the tubing is square and clean, measure and mark the insert depth on the outside of the.

PEX cutter), no burrs, and depth-marked and inserted the pex again.

Definitely worth the cost to make prepping the ends of your pipes simple and hassle-free. This pipe connector is different than a . Mark insertion depth using U7tool or measuring tape (see chart below). Cut the pipe square removing rough edges and debris. Deburring and Depth Gauge Tool, Clips, or De-Mount Tools.

Measure the insertion depth on the pipe or tubing end. The fittings have an insertion line molded into the body of the fitting. For PEX Pipe used with Series 3 . The Depth Gauge allows you to mark the proper pipe insertion depth to ensure . Each fitting increases ease of use while decreasing the time and effort needed to. A 1” mark on the pipe can be used as aguideline.

Proper insertion depths arelisted below. CPVC piping the tube liner must .