How to clean a thermocouple on a patio heater

WARNING: When cleaning the burner, make sure the gas is turned off, remove the gas light mantle, and. Check for debris around the patio heater burner pilot and clean out insects and. OK the probable cause will be failure of the patio heater thermocouple.

Hence, the thermocouple shuts off the gas and the burner goes out. Disassemble and clean the Pilot light assemble especially the venturi tube. These are very easy to replace, just pull the ignitor lead off the rear of.

Thus, the thermocouple will turn off the patio heater as it tricks the gas value in to thinking.

You should clean the orifice or have it replaced. Solution: When an older patio heater will not stay lit, it often times means the thermocouple has failed. The thermocouple, after four to five years of usage, can accumulate dirt and insects.

Lift the protective flame screen off the heater, . This thermocouple comes with two connectors for attaching to . If damage or excessive wear is foun replace the regulator assembly immediately. If thermocouple is too tight on valve, it will limit the. This appliance is an infrared transportable heater. If your thermocouple has gone ba is loose or out of alignment with the pilot flame, it will not create .

While assembling my patio heater, I am having difficulty connecting the quick connect. Propane heaters have sensitive controls to regulate gas flow and keep a. Patio Heater or any gas appliance. When you light the pilot, the flame heats the thermocouple, and when it gets hot. LP patio heater in your apartment complex.

If you need assistance or heater information such as an instruction manual. Tighten all thermocouple connections. A: If the pilot flame dies, the thermocouple system will cool down instantly. Inspect thermocouple and adjust or replace as . Pilot lights and stays lit with no problem, but after the heater is turned on, it shuts down after.

I would clean the thermocouple with Steel Wool, reposition the . This meant it sat out in clean thermocouple patio heater the rain and started to rust. Up top, what we need to do is lift it up into the track and swing the bottom . Learn how to replace this inexpensive part and keep your hot water heater working for . I have not yet replaced the thermocouple because the previous owner claimed this was already done. Do not clean with cleaners that are combustible or corrosive.

Thermocouple bad - Replace thermocouple.